CAMBARA Decking Installation Instructions Handling: Cambara decking is a kiln-dried product. It should be kept clean and dry, stacked off of the ground and stored for proper air circulation. End Sealing: After crosscutting, it is recommended to seal all ends within 24 hours with a clear aqueous wax end sealer. We recommend Anchorseal by UC Coatings. This will reduce end checking. Fastening: Stainless steel fasteners are highly recommended for their superior corrosion resistance combined with maximum holding power and ease of use. Drill pilot holes at ends of boards and stay ¾” from the edges to avoid splitting. Installation: 1x4 decking should be installed on 12” o.c. and the 5/4x4 and the 5/4x6 decking on 16” o.c. joists. Allow a gap of at least ¼” between boards to allow for air circulation and expansion. Important Points: 1) Adequate cross-ventilation is very important. Decks should lie at least 24" above the underlying surface and have open ventilation from three sides. 2) All deck boards should be end-sealed immediately following cross-cutting. Finishing: We recommend that Cambara decking be treated on all six sides with a high quality finish containing UV inhibitors prior to installation. This will add to the longevity and performance of your decking. Specifically, we recommend Messmers UV Plus, which we have found to be excellent at maintaining the traditional appearance of a Cambara deck. Messmers is available through Thompson Mahogany in gallon-sized cans. Following installation, Messmers should be applied to your Cambara deck once a year for maintenance. Thompson Mahogany Company Office: 7400 Edmund St Philadelphia PA, 19136 Warehouse: 225 Lincoln Highway Fairless Hills, PA 19030 Phone:800-589-6637 Fax:215-269-7354 www.thomahog.com